** SAMPLE OUTPUT FROM DEBUG SERIAL PORT ** RomBOOT > Entry: Kernel Loader v4.0.0 [SPI] Sending command: 0xD7 0x00 0x00 0x00 0x0002 [SPI] Device status = 0xBE PHY: LXT972 Autoboot in 3 . 2 . 1 . > > >t console=ttyS0,115200 root=/dev/mtdblock0 rootfstype=yaffs2 mem=64M >spi_read 43080 22400000 200000Sector protect enabled Sector protect enabled Sector protect enabled >e 22400000Uncompressing Linux.................................................. ...................................................... done, booting the kernel. [ 0.000000] Linux version 2.6.24 (root@kbdev-laptop13) (gcc version 3.4.2) #2 Thu Mar 6 10:19:51 MST 2008 [ 0.000000] CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177 [ 0.000000] Machine: KwikByte CAM60 [ 0.000000] Memory policy: ECC disabled, Data cache writeback [ 0.000000] Clocks: CPU 200 MHz, master 100 MHz, main 10.000 MHz [ 0.000000] CPU0: D VIVT write-back cache [ 0.000000] CPU0: I cache: 8192 bytes, associativity 4, 32 byte lines, 64 set s [ 0.000000] CPU0: D cache: 8192 bytes, associativity 4, 32 byte lines, 64 set s [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pag es: 16256 [ 0.000000] Kernel command line: console=ttyS0,115200 root=/dev/mtdblock0 roo tfstype=yaffs2 mem=64M [ 0.000000] AT91: 96 gpio irqs in 3 banks [ 0.000000] PID hash table entries: 256 (order: 8, 1024 bytes) [ 0.000000] Console: colour dummy device 80x30 [ 0.000000] console [ttyS0] enabled [ 0.080000] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) [ 0.090000] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) [ 0.100000] Memory: 64MB = 64MB total [ 0.110000] Memory: 61452KB available (2968K code, 322K data, 116K init) [ 0.110000] SLUB: Genslabs=11, HWalign=32, Order=0-1, MinObjects=4, CPUs=1, N odes=1 [ 0.310000] Mount-cache hash table entries: 512 [ 0.310000] CPU: Testing write buffer coherency: ok [ 0.320000] net_namespace: 64 bytes [ 0.330000] NET: Registered protocol family 16 [ 0.360000] SCSI subsystem initialized [ 0.370000] usbcore: registered new interface driver usbfs [ 0.370000] usbcore: registered new interface driver hub [ 0.380000] usbcore: registered new device driver usb [ 0.420000] NET: Registered protocol family 2 [ 0.430000] Time: pit clocksource has been installed. [ 0.530000] IP route cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.540000] TCP established hash table entries: 2048 (order: 2, 16384 bytes) [ 0.540000] TCP bind hash table entries: 2048 (order: 1, 8192 bytes) [ 0.550000] TCP: Hash tables configured (established 2048 bind 2048) [ 0.560000] TCP reno registered [ 0.590000] NetWinder Floating Point Emulator V0.97 (double precision) [ 0.600000] audit: initializing netlink socket (disabled) [ 0.600000] audit(0.598:1): initialized [ 0.660000] VFS: Disk quotas dquot_6.5.1 [ 0.660000] Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) [ 0.690000] yaffs Mar 6 2008 10:11:10 Installing. [ 0.700000] io scheduler noop registered [ 0.700000] io scheduler anticipatory registered [ 0.700000] io scheduler deadline registered [ 0.710000] io scheduler cfq registered (default) [ 0.760000] atmel_usart.0: ttyS0 at MMIO 0xfefff200 (irq = 1) is a ATMEL_SERI AL [ 0.790000] RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 block size [ 0.800000] loop: module loaded [ 0.840000] MACB_mii_bus: probed [ 0.840000] eth0: Atmel MACB at 0xfffc4000 irq 21 (##:##:##:##:##:##) [ 0.850000] eth0: attached PHY driver [Generic PHY] (mii_bus:phy_addr=fffffff f:00, irq=-1) [ 0.860000] Driver 'sd' needs updating - please use bus_type methods [ 0.870000] SCSI Media Changer driver v0.25 [ 0.870000] Driver 'ch' needs updating - please use bus_type methods [ 0.900000] NAND device: Manufacturer ID: 0x2c, Chip ID: 0xd3 (Micron NAND 1G iB 3,3V 8-bit) [ 0.900000] AT91 NAND: 8-bit, HardwareSYN ECC [ 0.910000] Scanning device for bad blocks [ 1.140000] Creating 1 MTD partitions on "at91_nand": [ 1.150000] 0x00000000-0x40000000 : "nand_fs" [ 1.160000] atmel_spi atmel_spi.0: Atmel SPI Controller at 0xfffc8000 (irq 12 ) [ 1.170000] mtd_dataflash spi0.0: AT45DB642x (8448 KBytes) [ 1.170000] Creating 4 MTD partitions on "spi_flash": [ 1.180000] 0x00000000-0x00001080 : "BOOT1" [ 1.180000] 0x00001080-0x00043080 : "BOOT2" [ 1.190000] 0x00043080-0x0027fe40 : "kernel" [ 1.200000] 0x0027fe40-0x00840000 : "file system" [ 1.210000] at91_ohci at91_ohci: AT91 OHCI [ 1.210000] at91_ohci at91_ohci: new USB bus registered, assigned bus number 1 [ 1.220000] at91_ohci at91_ohci: irq 20, io mem 0x00500000 [ 1.290000] usb usb1: configuration #1 chosen from 1 choice [ 1.300000] hub 1-0:1.0: USB hub found [ 1.300000] hub 1-0:1.0: 1 port detected [ 1.420000] Initializing USB Mass Storage driver... [ 1.420000] usbcore: registered new interface driver usb-storage [ 1.430000] USB Mass Storage support registered. [ 1.430000] usbcore: registered new interface driver libusual [ 1.440000] mice: PS/2 mouse device common for all mice [ 1.450000] i2c /dev entries driver [ 1.450000] TCP cubic registered [ 1.460000] NET: Registered protocol family 1 [ 1.460000] NET: Registered protocol family 17 [ 1.470000] RPC: Registered udp transport module. [ 1.480000] RPC: Registered tcp transport module. [ 1.480000] drivers/rtc/hctosys.c: unable to open rtc device (rtc0) [ 1.490000] yaffs: dev is 32505856 name is "mtdblock0" [ 1.490000] yaffs: passed flags "" [ 1.500000] yaffs: Attempting MTD mount on 31.0, "mtdblock0" [ 2.520000] VFS: Mounted root (yaffs2 filesystem) readonly. [ 2.530000] Freeing init memory: 116K init started: BusyBox v1.9.0 (2008-03-07 10:33:28 MST) starting pid 340, tty '/dev/ttyS0': '/sbin/getty' -------------------- - - - KwikByte KB9260 - - - - www.kwikbyte.com - - - -------------------- KB9260 login: