KwikByte KB9202x Copy Loader v0.9 Loading boot loader. . . done U-Boot 1.2.0 (Sep 26 2007 - 17:32:22) DRAM: 64 MB NAND: NAND device: Manufacturer ID: 0x2c, Chip ID: 0xda (Micron NAND 256MiB 3,3V 8-bit) 256 MiB DataFlash:AT45DB642 Nb pages: 8192 Page Size: 1056 Size= 8650752 bytes Logical address: 0xC0000000 Area 0: C0000000 to C00020FF Copy Loader (8kB) Area 1: C0002100 to C00041FF Environment (8kB) Area 2: C0004200 to C003665F U-Boot (195kB) Area 3: C0036660 to C0041FFF Secondary Boot (45kB) Area 4: C0042000 to C0461FFF OS (4MB) Area 5: C0462000 to C083FFFF DF_SPARE In: serial Out: serial Err: serial Hit any key to stop autoboot: 1  0 ## Booting image at 23000000 ... Image Name: KB9202 2.6.20 kernel Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 3262608 Bytes = 3.1 MB Load Address: 20008000 Entry Point: 20008000 Verifying Checksum ... OK OK Starting kernel ... Linux version 2.6.20 (root@dev.kwikbyte.com) (gcc version 3.4.5) #38 Fri Feb 23 16:37:48 MST 2007 CPU: ARM920T [41129200] revision 0 (ARMv4T), cr=c0007177 Machine: KB920x Memory policy: ECC disabled, Data cache writeback Clocks: CPU 180 MHz, master 60 MHz, main 10.000 MHz CPU0: D VIVT write-back cache CPU0: I cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets CPU0: D cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets Built 1 zonelists. Total pages: 16256 Kernel command line: console=ttyS0,115200 noinitrd root=/dev/mtdblock0 rootfstype=jffs2 mem=64M AT91: 96 gpio irqs in 3 banks PID hash table entries: 256 (order: 8, 1024 bytes) Console: colour dummy device 80x30 Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) Memory: 64MB = 64MB total Memory: 61464KB available (2928K code, 358K data, 108K init) Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok NET: Registered protocol family 16 SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 2048 (order: 3, 32768 bytes) TCP bind hash table entries: 1024 (order: 2, 20480 bytes) TCP: Hash tables configured (established 2048 bind 1024) TCP reno registered NetWinder Floating Point Emulator V0.97 (double precision) audit: initializing netlink socket (disabled) audit(0.530:1): initialized VFS: Disk quotas dquot_6.5.1 Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) JFFS2 version 2.2. (NAND) (C) 2001-2006 Red Hat, Inc. io scheduler noop registered io scheduler anticipatory registered io scheduler deadline registered io scheduler cfq registered (default) s1d15605fb s1d15605fb.0: 1KiB frame buffer at c3d20400 (mapped at c3d20400) Console: switching to mono frame buffer device 32x10 s1d15605fb s1d15605fb.0: Driver $Revision: 1.0 $ atmel_usart.0: ttyS0 at MMIO 0xfefff200 (irq = 1) is a ATMEL_SERIAL atmel_usart.1: ttyS1 at MMIO 0xfffc0000 (irq = 6) is a ATMEL_SERIAL atmel_usart.2: ttyS2 at MMIO 0xfffc4000 (irq = 7) is a ATMEL_SERIAL RAMDISK driver initialized: 16 RAM disks of 16384K size 1024 blocksize loop: loaded (max 8 devices) at91_ether: Your bootloader did not configure a MAC address. eth0: Link down. eth0: AT91 ethernet at 0xfefbc000 int=24 10-HalfDuplex (00:00:00:00:00:00) eth0: Intel LXT971A PHY NAND device: Manufacturer ID: 0x2c, Chip ID: 0xda (Unknown NAND 256MiB 3,3V 8-bit) Scanning device for bad blocks Bad eraseblock 1301 at 0x0a2a0000 Creating 1 MTD partitions on "NAND 256MiB 3,3V 8-bit": 0x00000000-0x10000000 : "nand_fs" at91_ohci at91_ohci: AT91 OHCI at91_ohci at91_ohci: new USB bus registered, assigned bus number 1 at91_ohci at91_ohci: irq 23, io mem 0x00300000 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected Initializing USB Mass Storage driver... usbcore: registered new interface driver usb-storage USB Mass Storage support registered. usbcore: registered new interface driver libusual usbcore: registered new interface driver usbhid drivers/usb/input/hid-core.c: v2.6:USB HID core driver mice: PS/2 mouse device common for all mice AT91 MMC: 4 wire bus mode not supported by this driver - using 1 wire TCP cubic registered NET: Registered protocol family 1 NET: Registered protocol family 17 Empty flash at 0x00003ffc ends at 0x00004000 -- cut -- Empty flash at 0x0017657c ends at 0x00176800 JFFS2 notice: (187) check_node_data: wrong data CRC in data node at 0x00178800: read 0x755e0c0a, calculated 0x60518343. VFS: Mounted root (jffs2 filesystem). Freeing init memory: 108K init started: BusyBox v1.1.2 (2006.10.03-22:35+0000) multi-call binary ---------------------------------- - - - Sample file system for KB9202B - - - ---------------------------------- KB9202B login: